-5%
HWIC-1CE1T1-PRI
Model: HWIC-1CE1T1-PRI Cisco Router High-Speed WAN Interface card
Details: 1 port channelized T1/E1 and PRI HWIC (data only) Cisco Router High-Speed WAN Interface card
Condition: New Factory Sealed
Warranty: 3 Years Warranty.
Description
HWIC-1CE1T1-PRI Overview
Quick Specs Figure 1 shows the appearance of HWIC-1CE1T1-PRI.
Table 1 shows the Quick Specs.
| Description | 1 port channelized T1/E1 and PRI HWIC (data only) Cisco Router High-Speed WAN Interface card |
| Diagnostic Loopback Support | • E1 loopback modes:• Controller local loopback• Interface local loopback• T1 loopback modes:• Interface local loopback• Interface remote loopback• Controller local loopback• Controller remote loopback• CSU loopback modes for T1 CSU:• Data terminal equipment (DTE) loopback• Network loopback• Payload loopback |
| Alarm Detection | • Yellow Alarm-Receive/Send from/to network• Blue Alarm-Receive alarm indication signal (AIS) from network• Red Alarm-Loss of network signal |
| Relevant MIB Support | • T1 MIB (RFC1406-MIB)• Cisco Integrated DSU/CSU MIB (CISCO-ICSUDSU-MIB) |
| Remote Management | • Cisco CNS 2100 Series Intelligence Engine (IE2100)• CiscoWorks |
| Signaling Debugging | • ISDN Q.921 and Q.931 decode• All other previously existing applicable Cisco IOS Software debugs |
| Dimensions (H x W x D) | • HWIC-1CE1T1-PRI: 0.75 x 3.08 x 4.74 in.• (1.91 x 7.82 x 12.04 cm) |
| Weight | • HWIC-1CE1T1-PRI: 0.18 lb (0.08 kg) |
| Operating Temperature | • 32 to 104°F (0 to 40°C) |
| Nonoperating Temperature | • -40 to 158° F (-40 to 70°C) |
| Relative Humidity | • 5-95% noncondensing |
| LEDs | LEDs per port• Carrier Detect/Loopback (CD/LP):• Off = No carrier detect• Green On = Carrier detect• Yellow On = Port in loopback mode• Alarm (AL):• Off = No alarms• Yellow On = Port in alarm modeLEDs per module (on NM-8CE1T1-PRI only):• EN:• Off = Card not available• On = Card enabled |
| Ports | • 1, 2, or 8 T1/E1 ports on RJ-48C connectors |
| Line Bit Rate (per Port) | • E1: (2.048 Mbps)• T1: (1.544 Mbps) |
| Line Coding | • E1: High-density bipolar three (HDB3 )• T1: Alternate mark inversion (AMI) and binary 8-zero substitution (B8ZS |
| Framing Formats | • E1: CRC4• T1: Super Frame (SF) and Extended Super Frame (ESF) |
| Output Levels | • E1: short-haul/long-haul• T1 (line build-out [LBO]): 0, -7.5, or -15 dB |
Get more information
Do you have any question about the HWIC-1CE1T1-PRI?
Contact us now via Live Chat or sales@metafinitivetech.com
