-5%
SPA-8XCHT1/E1
Model: SPA-8XCHT1/E1 Cisco ASR 9000 Series Shared Port Adapter
Details: Cisco ASR 9000 Adapter SPA-8XCHT1/E1 8-port Channelized T1/E1 to DS0 Shared Port Adapter
Condition: New Factory Sealed
Warranty: 3 Years Warranty.
Description
SPA-8XCHT1/E1 Overview
Quick Specs Figure 1 shows the appearance of SPA-8XCHT1/E1.
Table 1 shows the Quick Specs.
| Description | Cisco ASR 9000 Adapter, SPA-8XCHT1/E1, 8-port Channelized T1/E1 to DS0 Shared Port Adapter |
| Product Name | Cisco 8-Port Channelized T1/E1 Shared Port Adapter |
| Product compatibility | Cisco Catalyst 6500 Series SwitchesCisco 7600 Series RoutersCisco 12000 Series RoutersCisco XR 12000 Series RoutersCisco ASR 1000 Series RouterCisco ASR 9000 Series Router |
| Port density per SPA | 8 ports |
| Physical interface | • RJ-45 connector• RJ-45 to BNC adapter cable option |
| Protocols | Encapsulation protocols:• HDLC• Point-to-Point Protocol (PPP), RFC 1662• Frame Relay, RFC 1490Multilink support:• MLPPP, RFC 1990• MLFR, FRF.16• LFI over Frame Relay (FRF.12) and MLPPP |
| Features and functions | • Up to 8 independent T1 or E1 ports configurable as either all T1 or all E1 only• Full-duplex connectivity• Channelized and fractional T1/E1, clear channel E1 supported• Up to 256 usable n x 64K, where n is 1 to 24 for T1 and 1 to 32 for E1• Line-rate performance for all ports channelized to DS-0• Integrated CSUs/DSUs• Internal or network clocking selectable on each port• Per-port, dual-color status LED• Loopback capabilities:• Local and remote loopback at the T1/E1 level• Response to embedded loopback commands• Insertion of loopback commands into transmitted signal• N x DS-0 system-side loopback• Bit-error-rate-testing (BERT) pattern generation and detection per channel (maximum of 6 T1/E1 at a time)• Programmable pseudorandom pattern up to 32 bits long, including all 0s, all 1s, 211, 215, 220, 220 Quasi-Random Signal Sequence (QRSS), 223, alternating 0s and 1s, 1-in-8, and 3-in-24• 32-bit error-count and bit-count registers• Fully independent transmit and receive sections• Detection of test patterns with bit error rates up to 10-2• 24-hour history maintained for error statistics and failure counts, at 15-minute intervals• 16- and 32-bit cyclic redundancy check (CRC); 16-bit default |
| T1-specific features | • Data rate to 1.536 Mbps per port• Impedance: 100 ohms• D4 Super Frame (SF) or Extended Super Frame (ESF) framing• Alternate mark inversion (AMI) or binary 8-zero substitution (B8ZS) line encoding• ANSI T1.403 and AT&T TR 54016 Facility Data Link (FDL)• Selectable T1 cable length in increments from 0 to 655 feet• Selectable T1 CSU line build-out (LBO): 0, -7.5, -15, and -22.5 dB• Selectable T1 CSU receiver gain: 26 or 36 dB• Alarm monitoring:• Alarm indication signal (AIS)• Out of frame (OOF)• Far-end alarm failure (yellow or distant alarm)• Performance data collection:• CRC and bit errors• Framing bit errors• Line errored seconds• Far-end errored seconds• Far-end severely errored seconds• Far-end unavailable seconds• Line coding violation (LCV) |
| E1-specific features | • Data rate to 2.048 Mbps (unframed mode) or 1.984 Mbps (framed mode) per port• Impedance: 120 ohms (RJ-45 to BNC adapter cable offers 75-ohm configuration option)• Unframed E1, CRC4, or non-CRC4 framing• High-density bipolar with three zeroes (HDB3) line encoding• Alarm monitoring:• AIS• OOF• Remote alarm indication (RAI)• Performance data collection:• CRC and bit errors• Framing bit errors• Far-end block error (FEBE)• LCV |
| Reliability and availability | • OIR• Single SPA software reset |
| MIBs | RFC 1406 MIB |
| Network management | Simple Network Management Protocol (SNMP) |
| Compliance and agency approvals | CE MarkingSafety• UL 60950• CSA 22.2 No.60950• IEC 60950• EN 60950• AS/NZS 3260• TS001EMC• CFR47• Part 15• ICES 003• EN55022• CISPR 22• AS/NZ 3548• VCCI• EN55024• EN50082-1• EN61000-6-1Telecom (T1)• ANSI T1.403Telecom (E1)• ITU G.703• G.704• G.706 |
| Environmental specifications | • Operating temperature: 41 to 104°F (5 to 40°C)• Storage temperature: -38 to 150°F (-40 to 70°C)• Operating humidity: 5 to 85% relative humidity• Storage humidity: 5 to 95% relative humidity |
Get more information
Do you have any question about the SPA-8XCHT1/E1?
Contact us now via Live Chat or sales@metafinitivetech.com
